Looking for some advice for the correct diode. I have a solinoid that is controled via a circuit that should apply 12v for 1.5 to 2 seconds to "energize" and then drop to 2v to "hold" this a factory made unit and there are no diagrams avalabe for it. The 12v energize function has failed but the 2v hold function is working. I wish to put a 12v feed to the solinoid via a momentary push button and use a diode to stop the 12v flowing back to the controller board. Im concerned that the volt drop across the diode will make the hold voltage to low.
Energize volt - 12v to14v dc
Energize current - 700ma or about 8w
Hold volt - 2v
Hold current - 300ma
I will post a diagram of my plans.
Any advice appreciated.
Mike
Energize volt - 12v to14v dc
Energize current - 700ma or about 8w
Hold volt - 2v
Hold current - 300ma
I will post a diagram of my plans.
Any advice appreciated.
Mike