I currently have the Dremel rotary tool and press to drill my PCBs. I am only marginally happy with it. Seems to be OK down to .6mm but after that the run out is just too great to drill an accurate hole. Add to that the vibration in the press just makes it a challenge to use.
I have a full size bench press that does a better job but the Dremel beats running down into the basement to use the press.
Two I found that get mixed reviews are:
Proxxon
http://www.amazon.com/Proxxon-28606...e=UTF8&qid=1450577225&sr=8-6&keywords=proxxon
and this one
http://www.amazon.com/SE-97511MDP-3.../dp/B0040YJTTU/ref=cm_cr_pr_bdcrb_top?ie=UTF8
I kind of like the fact it is all one unit. Seems it would be more stable.
Any one use either or have other suggestions?
I have a full size bench press that does a better job but the Dremel beats running down into the basement to use the press.
Two I found that get mixed reviews are:
Proxxon
http://www.amazon.com/Proxxon-28606...e=UTF8&qid=1450577225&sr=8-6&keywords=proxxon
and this one
http://www.amazon.com/SE-97511MDP-3.../dp/B0040YJTTU/ref=cm_cr_pr_bdcrb_top?ie=UTF8
I kind of like the fact it is all one unit. Seems it would be more stable.
Any one use either or have other suggestions?