Hello
Hope the title is clear BUT if NOT, I need a small circuit in size, that will run a motor for a desired amount of seconds then stop and then can be Easily reset by the operator. The specs are:
1) Main power 3.7v 1s Lipo
2) Motor brushed 3.7v, 1A Max draw.
3) Circuit needs to run 10 seconds OR can be user adjusted 5-15 seconds, then stops.
4) Reset by user by way of a magnet, plan on using Reed switch N.C open-off with magnet, remove magnet then restarts motor run.
5) Circuit size, has to fit inside of 8mm dia. tube. Might be slightly larger.
Any help with the circuit design would be Greatly appreciated.
Thanks
George
Hope the title is clear BUT if NOT, I need a small circuit in size, that will run a motor for a desired amount of seconds then stop and then can be Easily reset by the operator. The specs are:
1) Main power 3.7v 1s Lipo
2) Motor brushed 3.7v, 1A Max draw.
3) Circuit needs to run 10 seconds OR can be user adjusted 5-15 seconds, then stops.
4) Reset by user by way of a magnet, plan on using Reed switch N.C open-off with magnet, remove magnet then restarts motor run.
5) Circuit size, has to fit inside of 8mm dia. tube. Might be slightly larger.
Any help with the circuit design would be Greatly appreciated.
Thanks
George