Hello to all you gurus out there
Been working on a Samson powered mixer(active) with a power supply issue replaced the M50D060S Igbt also the powered MOSFETs and the l6598 and l6562n mosfet drivers .The issue i am facing is the smps keeps ticking with no output at the secondary.
If I disconnect the pin 1 on it l6562n the smps powers up fine will attach the circuit diagram,its been giving me a lot of grief and am my wits end any thoughts or info wold be much much appreciated ,was wondering if i run the unit with the pin 1 of l6562n desoldered or disconnected would it destroy the complete unit.
Been working on a Samson powered mixer(active) with a power supply issue replaced the M50D060S Igbt also the powered MOSFETs and the l6598 and l6562n mosfet drivers .The issue i am facing is the smps keeps ticking with no output at the secondary.
If I disconnect the pin 1 on it l6562n the smps powers up fine will attach the circuit diagram,its been giving me a lot of grief and am my wits end any thoughts or info wold be much much appreciated ,was wondering if i run the unit with the pin 1 of l6562n desoldered or disconnected would it destroy the complete unit.