Inductance meter simple transistor

panic mode

Joined Oct 10, 2011
2,715
agreed....

if it is a common base, putting capacitor from base to gnd will not impede circuit's performance and - i don't see that here.

putting capacitor from emitter to gnd will have no notable effect on circuit.
 

ci139

Joined Jul 11, 2016
1,898
maybe hit's the target where there might have been discussion about small inductors design . . . or that or alike ? . . . can't find . . . but if i recall right they estimated it theoretically and calibrated to higher precision by signal delay measurement ← i don't think it's done cheap (but the document was originating back to 1960-70 . . . maybe there's some cheap signal timing meters avail. nowadays :eek:)
 
Last edited:

Thread Starter

Zeeus

Joined Apr 17, 2019
616
maybe hit's the target where there might have been discussion about small inductors design . . . or that or alike ?
don't understand...the links ?
Please do you know any meter that can measure low inductance? below 1uH

Resonance method? havent tried but doubt accuracy

thanks on 1st post
 
Last edited:
Top