I have a wheel with a hall sensor to count rpm.
I need a switch/control so that I can input the #of rotation I want the wheel to do.
If input 4...... The wheel will rotate 4 times.
Counting the halls sensors inputs on each rotation until reaching the input #
I was going to program an Arduino to do this but I have a feeling that there is an existing off the shelf component that will achieve my goals with less complication/work.
Thanks I hope someone picks up what I'm putting down.
I need a switch/control so that I can input the #of rotation I want the wheel to do.
If input 4...... The wheel will rotate 4 times.
Counting the halls sensors inputs on each rotation until reaching the input #
I was going to program an Arduino to do this but I have a feeling that there is an existing off the shelf component that will achieve my goals with less complication/work.
Thanks I hope someone picks up what I'm putting down.