Hi everybody
Until now , I design my ADC circuits with myself but i have new project that i need to use 32bit SAR ADC and i want send data from this ADC to the Atmega32 (8bit). as you know designing the PCB or drive circuit for this ADC`s is difficult and need time for finding errors and challenge with noise and ... So i make a decision that use the evaluation board but i haven`t any experience in it.
the LTC2500-32 is good for me and have a good features. and i found the DC2222A-A is the evaluation board of LTC2500-32 .but in datasheet i found this eval board make for some PDA .
I want use DC2222A-A stand alone without PDA . Can i do that or is it wisely ?!
thank you for sharing your experience or advice with me.

https://www.analog.com/media/en/dsp-documentation/evaluation-kit-manuals/dc2222afa.pdf
https://www.analog.com/media/en/technical-documentation/data-sheets/250032fb.pdf

 

You need to define "PDA," because neither of those references does so.

 

i talk about DC2026 , DC590 or DC890 . the boards that "DC2222A-A" can connect to them for reading or collecting data .

 

Can you duplicate the functions of those I/O boards? Do you need to?
A specification is called for here.

 

i don`t need these I/O but i want to run this ADC with my board.
in fact, i have the board that use Atmega32 that can send data with bluetooth module in my software.