Holding HT12D pin

Thread Starter

André Ferrato 1

Joined Jul 31, 2015
5
Hello, i am using a simple 433Mhz TX-RX system with HT12E and HT12D to enable a relay coil to close the circuit on another part of my house, but to ensure that the battery of the transmitter isn't drained all time, i need a circuit that holds the pin of the HT12D high to keep enabling the coil even if the transmitter only transmits at a brief moment, is that possible? Or i could use another options ? I don't know a thing about digital electronics, but i think the solution is there. Thanks.
 
Top