This scope has a x10 magnifier that you set by turning the cursor control wehile pressing the auto button.
If,say your on 50mv/div you can use that combination to up it to .5 mv/div.
Now that does work as seen in the lower left-hand of the sreen but the dispaly stays the same.
Say you have a signal thats 2 divg high on 50mv/div.
You do the combination and it now says .5 on the screen but the dispoaly stays at 2 div.
Shouldn`t it drop to not even 1 div at .5 volts?
If,say your on 50mv/div you can use that combination to up it to .5 mv/div.
Now that does work as seen in the lower left-hand of the sreen but the dispaly stays the same.
Say you have a signal thats 2 divg high on 50mv/div.
You do the combination and it now says .5 on the screen but the dispoaly stays at 2 div.
Shouldn`t it drop to not even 1 div at .5 volts?
