I am working on a Raspberry Pi Magic Mirror project, and need my Raspberry Pi to cost effectively detect a Z-Wave signal. I have a $16 Z-wave wall module that switches 120VAC on/off. I intend to wire that module to a relay using 120VAC as the control signal to toggle a low voltage signal. This low level signal will be detected by my Raspberry Pi.
I am experimenting with that relay now. Is is a Crydom IAC5 (spec sheet attached). I have wired as follows (picture attached):
Have I wired this incorrectly, or is it possible I have a defective unit?
Thank you,
Chris
I am experimenting with that relay now. Is is a Crydom IAC5 (spec sheet attached). I have wired as follows (picture attached):
- 120VAC wired to pins 1 and 2
- 5 VDC power supply wired to pin 3 (+5 VDC) and pin 5 (ground)
- Voltmeter wired to pins 4 and 5
Have I wired this incorrectly, or is it possible I have a defective unit?
Thank you,
Chris
Attachments
-
519.3 KB Views: 15
-
167.1 KB Views: 10