All About Circuits

extracting matching network data from S-param model of QPA2575

Search Forums New Posts
Y

Thread Starter

yef smith

Joined Aug 2, 2020
1,446
Hello , I noticed that my QPA2575 datasheet doesnt have any smithchart matching data.
which is intresting because other components like the component attached.
I hve only S-param model of QPA2575.
can i do load pull? or matching smith chard circles as shown bellow with only S-param model?
What benefit can i extract from the S-param model to descover the properties of the amplifier.
I know there are NF circles ,Gain circles etcc.. but i am not sure what can be done with S-param model?
Thanks.
https://www.qorvo.com/products/p/QPA2575#documents
1698695695404.png
 

Attachments

You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Y extracting CGHV1A250F basic parameters from a real life evalulation board PCB Layout , EDA & Simulations 0
Y extracting cgg and dgs from LTSPICE simulation model Analog & Mixed-Signal Design 6
S Extracting AC output voltage ripple and adding DC offset for ADC input Power Electronics 58
Y extracting spice model params from bjt plot IC Design 11
AlbertHall Extracting temperature values from DS18B20 Programming & Languages 9
Similar threads
extracting CGHV1A250F basic parameters from a real life evalulation board
extracting cgg and dgs from LTSPICE simulation model
Extracting AC output voltage ripple and adding DC offset for ADC input
extracting spice model params from bjt plot
Extracting temperature values from DS18B20

You May Also Like

Top