There is a RFsock4x2 board I need to use shown below,I need to run 4 signals from DAC depending on the gpio interrupt being raised.
I am new to vivado and vitis , I am asking general strategy on how to accomplish this .
We have two peripheris DAC and GPIO.
1.In MCU for each periphery we have API and registers with exact manual \regarding their functionality ,where can I find them?
2. How do you recommend me to implement this structure , general strategy?
3. any examples will be great.
Thanks.
https://www.realdigital.org/hardware/rfsoc-4x2

 

What's your experience in low level embedded programming? It helps to understand what the high level framework is doing.

Down the rabbit hole.

https://www.pynq.io/
https://www.amd.com/en/products/software/adaptive-socs-and-fpgas/vitis.html
https://www.amd.com/en/products/software/adaptive-socs-and-fpgas/vitis/vitis-embedded.html
https://adaptivesupport.amd.com/s/t...vitis-embedded-development-sdk?language=en_US

 

Hello , RFSoC block diagram shows that GPIO and ADC/DAC are not directly connected .could you give me strategy on how to do it?