Hi everyone.
As a hobbyist,I want to design a digital thermometer using an ATtiny85 controller and a thermistor.
The result will be displayed on a 4-digit seven segment display.
This is actually my first project involving a microcontroller so I need a lot of advice on what I'm about to do.
I don't really know where to start from.
The 7-segment has 12 pins and the MCU has 8.
The tutorials I went through used a max7219 to interface with the led and then the controller.
But the temp sensor in that case was a temp ic instead of a thermistor.
How do u think I should go about this
As a hobbyist,I want to design a digital thermometer using an ATtiny85 controller and a thermistor.
The result will be displayed on a 4-digit seven segment display.
This is actually my first project involving a microcontroller so I need a lot of advice on what I'm about to do.
I don't really know where to start from.
The 7-segment has 12 pins and the MCU has 8.
The tutorials I went through used a max7219 to interface with the led and then the controller.
But the temp sensor in that case was a temp ic instead of a thermistor.
How do u think I should go about this
Last edited: