Hello,
This is my last lab so it is the most difficult. I need to write down my logic and the gates used to reconfigure my two 7-segment display to operate as the hours used in a digital clock. So far I have an AND gate being used as the minutes which goes up to 59 and my logic for that is fine because it's only one AND gate. I am lost as to what to use to get one 74193 to stop @ 13 and the other to stop at 1, both need to be reset to 00. I hope this isn't too confusing because I finally understand it all after an entire semester working with these logic gates.
Thanks in advance!
This is my last lab so it is the most difficult. I need to write down my logic and the gates used to reconfigure my two 7-segment display to operate as the hours used in a digital clock. So far I have an AND gate being used as the minutes which goes up to 59 and my logic for that is fine because it's only one AND gate. I am lost as to what to use to get one 74193 to stop @ 13 and the other to stop at 1, both need to be reset to 00. I hope this isn't too confusing because I finally understand it all after an entire semester working with these logic gates.
Thanks in advance!