Hi, I have to design a sequence detector that accepts overlapping sequences for two 8-bit codes. The codes are 00110001 and 01110011. A logical 1 output will be generated when either one of two 8-bit code sequences are correctly detected sequentially.
So, I'm stuck at drawing the Mealy model state diagram. This is what I was able to draw (picture attached below). However, I don't know where to connect some of the states. For example, if the input at S6 is 1, I don't know if I should connect it to S3 or S9 as it can be a part of overlapping sequence for both sequences. I have the same problem for S7 and S13. Is my Mealy model state diagram right?
So, I'm stuck at drawing the Mealy model state diagram. This is what I was able to draw (picture attached below). However, I don't know where to connect some of the states. For example, if the input at S6 is 1, I don't know if I should connect it to S3 or S9 as it can be a part of overlapping sequence for both sequences. I have the same problem for S7 and S13. Is my Mealy model state diagram right?
Attachments
-
33.6 KB Views: 34