I have a 12 volt DC motor and when using a battery -- it kick start immediately without problem. However i don't want to waste the battery charge all the time considering that it need to be recharge all the time. So i directly using a step down DC adapter which is also rated at 12 volt 7 Amp. It does work but there is a problem...
When the switch is quickly press the motor will turn a while and then stop -- but when the switch is slowly press the motor will start slowly and eventually normal. I feel this is quite annoying i don't have the patience to switch slowly and then full...it would be good if it just turn the motor when the switch is on no matter how it is done.
Would anyone shed some light what could be the problem and how to remedy this?
When the switch is quickly press the motor will turn a while and then stop -- but when the switch is slowly press the motor will start slowly and eventually normal. I feel this is quite annoying i don't have the patience to switch slowly and then full...it would be good if it just turn the motor when the switch is on no matter how it is done.
Would anyone shed some light what could be the problem and how to remedy this?