Hi everyone ^_^
I've some basic questions regarding the Pinout Function of 4017.
1. If the RESET pin was connected to pin10 (5th seq. output)...
..the output will be from pin3 (1st seq. o/p) to pin7 (4th seq. o/p) only and back again to pin3 to pin7 and over and over again ?
2. If the pin13 (Clock/latch enable) is held high the sequence will stop as far as the pin 13 is high ? What if it is not connected to either + or Gnd terminal ?
3. What will be the output duty cycle of each output
(i.e. from 1st seq. to 3rd seq. with the RESET pin connected to 5th seq. o/p) if the clock input has a 50% duty cycle square wave ?
Thank you ^_^
I've some basic questions regarding the Pinout Function of 4017.
1. If the RESET pin was connected to pin10 (5th seq. output)...
..the output will be from pin3 (1st seq. o/p) to pin7 (4th seq. o/p) only and back again to pin3 to pin7 and over and over again ?
2. If the pin13 (Clock/latch enable) is held high the sequence will stop as far as the pin 13 is high ? What if it is not connected to either + or Gnd terminal ?
3. What will be the output duty cycle of each output
(i.e. from 1st seq. to 3rd seq. with the RESET pin connected to 5th seq. o/p) if the clock input has a 50% duty cycle square wave ?
Thank you ^_^