All About Circuits

Capture of multiple 2.4ghz & 5.8ghz signal and all displayed on one monitor

T

Thread Starter

Travelndog

Joined Dec 17, 2015
1
I need to capture about 5 - 10 video signals that will be either 2.4ghz or 5.8ghz and then display all of the signals onto one large TV monitor at the same time. What equipment would I need?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
J Oscope & Piezo Electric to capture Airgun Barrel Vibration ? General Electronics Chat 24
T Finding UART to USB to Capture 0-12V Digital Signal at 100 bits/sec General Electronics Chat 12
L i finished my circuit on capture cis but got this error after trying to simulate "pin B in template not found on R1" General Electronics Chat 0
L i finished my circuit on cis capture now all i need is to add the input data on the sheet Homework Help 2
barebear Where does the bit come from when capture the bits to scan cell in jtag Capture-DR stage? IC Design 1
Similar threads
Oscope & Piezo Electric to capture Airgun Barrel Vibration ?
Finding UART to USB to Capture 0-12V Digital Signal at 100 bits/sec
i finished my circuit on capture cis but got this error after trying to simulate "pin B in template not found on R1"
i finished my circuit on cis capture now all i need is to add the input data on the sheet
Where does the bit come from when capture the bits to scan cell in jtag Capture-DR stage?

You May Also Like

Top