Hello,

I'm using complex hierachical design and also would like to use few BOM variants for my PCB.
When I open the part manager in orcad, it gives me only the RefDe, but not in which "module" they are used.
How can I change that?
I want to be able to not assemble some of the modules completely.

 

Hello,

I'm using complex hierachical design and also would like to use few BOM variants for my PCB.
When I open the part manager in orcad, it gives me only the RefDe, but not in which "module" they are used.
How can I change that?
I want to be able to not assemble some of the modules completely.

Convert the design to flat

 

Thanks for your reply.

How will that help?
I want to be able to create the BOM variant through part manager.

 

Thanks for your reply.

How will that help?
I want to be able to create the BOM variant through part manager.

The flat design can be fabricated as individual modules or as a composite whole.