Similar to this post from 2013, Bunkerhill Security Light Modification I want to modify the light to disable the (low light) always-on-after-dark feature. I only want the motion activated (high, 120 lumen) light feature. The circuit board has been redesigned. The led array says 2016.06, and 2018 copywriter on the owners manual. I'm hoping like the older model I can remove/disable a resistor or component to disable the always-on-after-dark feature.
The unit is:
I measured the output for the low-mode (always-on) voltage at 2.57v, and the high-mode voltage at 2.77v. But I'm not certain the unit was fully charged.
If you has done this can you tell me how you did it?
Any idea where to look for find a schematic? There isn't one in the owners manual.
How can I temporarily disable the motion sensor so I can do some testing? I tried electrical tape over the sensor but that did not seem to work. I kept going into high-mode when I move.
The unit is:
- Brand: BUNKER HILL SECURITY
- Model: 120 Lumen Solar Motion Security Light
- 20 SMD LED array
- 3.2v, 600mAh Lithium Ion Batttery
- White SKUs: 64732, 64733
- Black SKUs: 64736, 64735
- circuit board number is: DG606a
I measured the output for the low-mode (always-on) voltage at 2.57v, and the high-mode voltage at 2.77v. But I'm not certain the unit was fully charged.
If you has done this can you tell me how you did it?
Any idea where to look for find a schematic? There isn't one in the owners manual.
How can I temporarily disable the motion sensor so I can do some testing? I tried electrical tape over the sensor but that did not seem to work. I kept going into high-mode when I move.