A couple of months ago I created a pair of test leads that where specifically designed to be used for a breadboard. (This design was a total flop).
Over the past couple of weeks, I’ve been using feedback from my original design to create a second revision (Rev2) of the breadboard test leads.
The new design will have the following specifications:
I attached a picture of the current design for Rev2. Since, this is my first attempt at the design, the dimensions and overall layout can still be changed.
I would appreciate some feedback on this new design. Thanks
<link removed, moderator>
Over the past couple of weeks, I’ve been using feedback from my original design to create a second revision (Rev2) of the breadboard test leads.
The new design will have the following specifications:
- 24 AWG - 40 Strands - Copper wire
- Length: 1 Meter
- 0.5mm rounded tampered steel pins
- Soild-State Banana Plug Gold Plated with a low contact resistance
I attached a picture of the current design for Rev2. Since, this is my first attempt at the design, the dimensions and overall layout can still be changed.
I would appreciate some feedback on this new design. Thanks
<link removed, moderator>
Last edited by a moderator: