Hi, my 1st post....
What I am after is a simple delay timer, running from 0 to say 100 milliseconds in steps of 0.1 milliseconds, with a display of the set time.
Two input buttons would be used to set the time (up or down)
Basically I will have a switched input, delay by X amount, then the output is triggered. Complete accuracy is not vital as long as it is constant.
Is this possible, if so where is the best place to start with the hardware. - PIC selection, display, USB Programmer?
Programming shouldn't be a problem apart from the output display maybe, and I'm ok with the PCB work - just never used PIC before.
Thanks,
Adam
What I am after is a simple delay timer, running from 0 to say 100 milliseconds in steps of 0.1 milliseconds, with a display of the set time.
Two input buttons would be used to set the time (up or down)
Basically I will have a switched input, delay by X amount, then the output is triggered. Complete accuracy is not vital as long as it is constant.
Is this possible, if so where is the best place to start with the hardware. - PIC selection, display, USB Programmer?
Programming shouldn't be a problem apart from the output display maybe, and I'm ok with the PCB work - just never used PIC before.
Thanks,
Adam