All About Circuits

Automatic Power Factor Correction using Atmega16

U

Thread Starter

Usama_ali143

Joined Jul 17, 2017
27
Hello experts guys ! i m working on the project "Automatic Power Factor Correction using Atmega16". I took current sample from resistor (schematic attached) and provided this sample at PAO of Atmega16 . Further more i took Voltage samples from Zero cross detector and provided this sample at PINC.4. Finally i tested my circuit at Bread board and it was working perfect. It was showing accuate power factor. but when i buiilt this circuit at PCB it does not taking sample of either voltage or current. please help me to troubleshoot. i m totalyy exhausted....
 

Attachments

You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
O Arduino Based Automatic Fan Speed controller using LM35 temperature sensor Homework Help 5
B Old invisible fence/collar to send kill signal to sons power wheels. Perfect perimeter already laid out General Electronics Chat 4
U Automatic power factor correction system using Atmega16 Microcontrollers 0
M Single Phase Automatic Displacement Power Factor Power Electronics 2
E automatic power factor corrector General Science, Physics & Math 2
Similar threads
Arduino Based Automatic Fan Speed controller using LM35 temperature sensor
Old invisible fence/collar to send kill signal to sons power wheels. Perfect perimeter already laid out
Automatic power factor correction system using Atmega16
Single Phase Automatic Displacement Power Factor
automatic power factor corrector

You May Also Like

Top