Facebook
Google
GitHub
Linkedin
I just bought an arduino pro mini 5V 16MHz from http://www.w11stop.com/arduino-pro-mini-5v-16mhz and now having trouble burning the code in it. The pro mini is all good but I am unable to burn the code using arduino uno. Please help me as I am new to the arduino world.
Arduino pro mini code burning
- Thread starter Danish45
- Start date
The most current software is IDE 1.8.1 Under Tools / Board / You should be choosing Arduino Pro or Pro Mini. You need to make sure your board is selected. Next, the programming header needs to be connected correctly to your programming source. Make sure the correct comm port is selected. You don't mention any errors which are specific?
This is a very good read on getting the board setup and programmed.
Ron
This is a very good read on getting the board setup and programmed.
Ron
I am selecting the arduino pro mini from my Board option in the IDE, I have removed the ATmega328 IC from my UNO and using the following connections to burn code in pro mini using UNO:
DTR -------- Reset
VCC ------- 5V
GND -------GND
RX -------RX
TX------------TX
DTR -------- Reset
VCC ------- 5V
GND -------GND
RX -------RX
TX------------TX
A Homeschoolers Workbench
- Joined Jul 26, 2016
- 142
This instructable might help https://www.instructables.com/id/How-to-Program-a-Arduino-Pro-Mini-Wo-a-Serial-Adap/
A.H.W.
A.H.W.
Also, read the information provided on the Arduino web site (https://www.arduino.cc/en/Guide/ArduinoProMini). As suggested there, you will need an FTDI cable or break-out board.
A Homeschoolers Workbench
- Joined Jul 26, 2016
- 142
You did not read my post you do NOT need a FTDI cable or break-out board.
A.H.W
now let me give you some suggestions you need to check first whether to install the driver of that ardino in your pc .you can found the driver with the kit that you bought in a cd form or you can download it.then start to install the ardino programming tool then use the guide to burn your code .
hope this will help you.
