Hey everyone, I'm new to this but I have a MC from a horizon mc1308aa02918 is on the mc housing and on the board it has MLH09131.
I'm curious if anyone has a schematic for the pin out on it? I'm wanting to use it with the motor it came with for a variable speed drill press but if it's a pain I also have a mc-60 controller to simplify it

 

The MC-60 is a good one, albeit it is SCR controlled bridge instead of the preferred PWM version.

 

The MC-60 is a good one, albeit it is SCR controlled bridge instead of the preferred PWM version.

Pwm would be nice but end of the day I'll use the mc-60. Trying to find a mc2000 or mc2100 when one comes for scrap