I am using the 74HC08N chip. Why doesn't the first AND gate latch itself ?
I have connected the output of the first AND gate to its own input.
I have used two resistors, the one on top is a pull-up and the one in the bottom is the pull-down
After I release the button, the diode should take care by feeding the current from the output back into the input, why this doesn't happen, the LED is not always turned on after I press the button once.
I have connected the output of the first AND gate to its own input.
I have used two resistors, the one on top is a pull-up and the one in the bottom is the pull-down
After I release the button, the diode should take care by feeding the current from the output back into the input, why this doesn't happen, the LED is not always turned on after I press the button once.
Last edited by a moderator: