high power

Search Forums New Posts
  1. G

    Recommendations for adjusting (rectification or voltage dividing etc..) the output of a 350VDC SMPS?

    Hello, I seldom have to work with high voltage/high power hardware, so I am looking for the safest low-cost approach. I am working with a TI Evalution Board/Reference Design for a Voltage Source Inverter. It requires a 350-400 VDC input (1.7A). My main objective or focus is on the firmware...
  2. salhi

    PCB Production EasyEDA

    I have this circuit schematic that i made in easyeda, i want to make the PCB Layout of it but only over the copper layer, and keep the components on the top components layer, but then i faced many problems , i want to make all the traces with the width of 1.2mm, beside the energy supply inputs...
  3. N

    Insulation for RG401 with Copper Shield when used a Power cable

    Hey everyone! I am Nio. I am currently working on building a cable that is used at high power application (1.5kW). The connectors I used at the terminals are N type and HN type connectors so I had to use a RG401 cable. I bought one of Multicomp Pro make. The cable has internal conductor covered...
Top