Dear,
i am developing an home automation application by using W7230F1 (EFR32MG12 2.4Ghz Mesh Networking Kit-mighty gecko-10/19db).
here i created network between TWO devices in Simplicity Studio V5. later i did Launch Console in the IDE and i ping reciever ip address to sender. then i send commands from sender to receiver device and i received commands which i sent from sender device. i did this using UDP Protocol. but problem here in UDP i didnt have the Acknowledgement message to the sender from the reciever device.
i want a Acknowledgement message from the reciever to sender device in this process. please let me what is the better way to approch solution for this.
thanking you in advance.
Regards
sri naga
i am developing an home automation application by using W7230F1 (EFR32MG12 2.4Ghz Mesh Networking Kit-mighty gecko-10/19db).
here i created network between TWO devices in Simplicity Studio V5. later i did Launch Console in the IDE and i ping reciever ip address to sender. then i send commands from sender to receiver device and i received commands which i sent from sender device. i did this using UDP Protocol. but problem here in UDP i didnt have the Acknowledgement message to the sender from the reciever device.
i want a Acknowledgement message from the reciever to sender device in this process. please let me what is the better way to approch solution for this.
thanking you in advance.
Regards
sri naga
Last edited by a moderator: