Ok electronics -Gods,
i need some help designing a controller for a piece of equipment we have. I have an inline 120v A/C blower that draws 295 watts at full speed. I am looking to have the blower run CONTINUOUSLY at ~80%, and have a thermostat monitor the cabinet temperature. As the temperature goes above 95 degrees F the fan needs to increase in speed until and reach full speed should the internal temperature go above 100-110 F.
As the temp comes back down the blower should stay at speed until below 95 F then back to 80%.
Can someone help me out? Thanks in advance!
i need some help designing a controller for a piece of equipment we have. I have an inline 120v A/C blower that draws 295 watts at full speed. I am looking to have the blower run CONTINUOUSLY at ~80%, and have a thermostat monitor the cabinet temperature. As the temperature goes above 95 degrees F the fan needs to increase in speed until and reach full speed should the internal temperature go above 100-110 F.
As the temp comes back down the blower should stay at speed until below 95 F then back to 80%.
Can someone help me out? Thanks in advance!