Smallest recharable power option

Thread Starter

stoopkid

Joined Mar 3, 2011
146
I'm working on a small project(hopefully small enough to fit in a necklace locket) that consists of a atmega85(using about 2mA) and one RGB LED(that I will probably try to get under 20 or 30mA for all three colors). A couple of stacked cr2032's would work but it would be really nice if I didn't have to burn through them. I'm looking at rechargeable 2032's but I figured instead of conforming to a standard size, I should be looking for best capacity/size.

So im looking for as small as possible, flat being a priority, and getting as close to 5v as I can.

Thanks
 

MrChips

Joined Oct 2, 2009
35,299
I can only assume that you are attempting to create some kind of wearable device with LEDs. Your objective should be to keep the power consumption down to a minimum. Here is what I would do.

1. There are MCUs that consume very low power, in the micro-amp ranges.

2. Operate the LED and maybe even the MCU in a pulsed mode, sleep/wakeup in order to reduce the current drain.

3. Operate off a single 3V coin battery. This will simplify the physical assembly.

4. Use high efficiency LEDs that operate with less than 1mA.
 
Thread starter Similar threads Forum Replies Date
MrChips Microcontrollers 18
Similar threads
World's smallest MCU
Top