i've purchased two TowerPro MG995 servos and testing them was a bit confusing (I'm a bit new to servos). They do not have the same output angles coming from the same program uploaded into the microcontroller. Now, I want the servo to rotate to a specific angle then stays constant and retracts until specified in the program.
Now upon testing i'm confused that the servo does not achieve the precise angle and also rotates back to its original position after achieving its maximum angle from the program.
Can anyone enlighten mo on this?
Thanks a lot!
Now upon testing i'm confused that the servo does not achieve the precise angle and also rotates back to its original position after achieving its maximum angle from the program.
Can anyone enlighten mo on this?
Thanks a lot!