Facebook
Google
GitHub
Linkedin
hi every one
please take a look at this project... size is just 26 KB.
http://www.2shared.com/file/l53Hzyig/dc_-atmega16-pwm_.html
i programmed my Atmega16 whit the hex file in this project. but i wanna know that is it enough (( to pruduce PWM pulses )) to programm the IC using the hex file or I should define some other parameters to run my DC engine (( using code wizard AVR in codevision ))
_________________
and the other question is about the 30th pin of atmega 16 named (( avcc ))
should i connect this pin to 5volt supply shen i connected the ((vcc)) to this voltage or i should release it...?
in other word two wires for these pins (( vcc & Avvc )) or just one wire for VCC...??
_________________
please do me a favour and answer my question
thanx..!!
please take a look at this project... size is just 26 KB.
http://www.2shared.com/file/l53Hzyig/dc_-atmega16-pwm_.html
i programmed my Atmega16 whit the hex file in this project. but i wanna know that is it enough (( to pruduce PWM pulses )) to programm the IC using the hex file or I should define some other parameters to run my DC engine (( using code wizard AVR in codevision ))
_________________
and the other question is about the 30th pin of atmega 16 named (( avcc ))
should i connect this pin to 5volt supply shen i connected the ((vcc)) to this voltage or i should release it...?
in other word two wires for these pins (( vcc & Avvc )) or just one wire for VCC...??
_________________
please do me a favour and answer my question
thanx..!!
