Hi everyone. I'm using a PIC16F690 and have a simple program that flashes two LED's alternatively.
At the moment the PIC is plugged into a low pin count demo board and is programmed with the PICKit2 programmer.
My program is done with FLOWCODE 5 and works great.
What I want to know is how to run the PIC in its own circuit without the PICKit2 programmer or low pin count demo board. I think the PIC is currently being run by an internal clock, and can I also use it independantly from the programmer etc???
I'm totally new to this and would appreciate any help.
Thanks a lot-JDR04
At the moment the PIC is plugged into a low pin count demo board and is programmed with the PICKit2 programmer.
My program is done with FLOWCODE 5 and works great.
What I want to know is how to run the PIC in its own circuit without the PICKit2 programmer or low pin count demo board. I think the PIC is currently being run by an internal clock, and can I also use it independantly from the programmer etc???
I'm totally new to this and would appreciate any help.
Thanks a lot-JDR04
Last edited: