All About Circuits

need pulser board and tranceiver switch

Search Forums New Posts
Status
Not open for further replies.
B

Thread Starter

bosechandran

Joined Jan 6, 2017
7
hi
i need high voltage pulser board and high voltage transceiver switch for 8 channel ultrasound signal. can u say where i can get free sample or lowest cost module.
thanks from chandran
 
Status
Not open for further replies.
Thread starter Similar threads Forum Replies Date
K Do FRAMs need their CE (bar) signal pulsed? Microcontrollers 2
T Do i need to match all nos General Electronics Chat 10
T oscilloscope sens not low enough, need preamp to observe signal, common base good amp for this? General Electronics Chat 15
I Need help for close-loop scalar control of induction motor Homework Help 7
inwo Circuit help -Need HV Pulser driven from TTL General Electronics Chat 7
Similar threads
Do FRAMs need their CE (bar) signal pulsed?
Do i need to match all nos
oscilloscope sens not low enough, need preamp to observe signal, common base good amp for this?
Need help for close-loop scalar control of induction motor
Circuit help -Need HV Pulser driven from TTL

You May Also Like

Top