All About Circuits

MPLAB ICD pinout

Search Forums New Posts
K

Thread Starter

Kardo22

Joined Mar 12, 2014
51
Hi,
I think I'm going crazy because of this. Programmer's datasheet talks about target board pins but I want to make a custom cable to the programmers RJ11 connector. I've found it both ways but this is the most common that MCLR is pin6.
Is it correct that on the programmer MCLR is pin 6 (rightmost)?
1739366497096.png
1739366519719.png
 
Last edited:
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Arjune How do I modify my PIC microcontroller program to deliver 150 hz also with the existing 1hz output Microcontrollers 154
nsaspook MPLAB vs-code extensions Programming & Languages 0
atferrari 18F4585 .inc file MPLAB X Assembly with pic-as Microcontrollers 10
nsaspook MPLAB® PICkit™ Basic In-Circuit Debugger Microcontrollers 2
M Build Problem MPLAB v6.20 Software & IDEs 1
Similar threads
How do I modify my PIC microcontroller program to deliver 150 hz also with the existing 1hz output
MPLAB vs-code extensions
18F4585 .inc file MPLAB X Assembly with pic-as
MPLAB® PICkit™ Basic In-Circuit Debugger
Build Problem MPLAB v6.20

You May Also Like

Top