All About Circuits

Hyperlynx 8.0 simulation (newbie question)

Search Forums New Posts
N

Thread Starter

NY10

Joined Jul 30, 2010
47
Hi, all

When I simulated the AC circuit, the waveform was generated. The vertical axis was magnitude (dB) and horizontal axis was frequency (Hz)

I would like to change the vertical axis to voltage (V). How can I change vertical axis magnitude (dB) to voltage (V).

Please let me know.

Thanks.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A Signal integrity analysis HYPERLYNX Digital Design 2
S Hyperlynx PCB Layout , EDA & Simulations 0
J How to adjust PCIE signals using Hyperlynx S- Parameter report? PCB Layout , EDA & Simulations 0
E How to change trace width and spacing of diff pairs in the design using MentorGraphics Hyperlynx SI PCB Layout , EDA & Simulations 0
A Assign model in hyperlynx General Electronics Chat 0
Similar threads
Signal integrity analysis HYPERLYNX
Hyperlynx
How to adjust PCIE signals using Hyperlynx S- Parameter report?
How to change trace width and spacing of diff pairs in the design using MentorGraphics Hyperlynx SI
Assign model in hyperlynx

You May Also Like

Top