Hi,
In the below image, I want to cut only this small circled piece:
So, I hit right click and click on unroute segment:
It does delete it but keeps both pads connected:
So, how can I just chip off/delete/cut/remove any piece of the line/trace/connector/wire, whatever you want to call it, forever?
Thanks
In the below image, I want to cut only this small circled piece:
So, I hit right click and click on unroute segment:
It does delete it but keeps both pads connected:
So, how can I just chip off/delete/cut/remove any piece of the line/trace/connector/wire, whatever you want to call it, forever?
Thanks