Hello,there is an amplfier board of QPA2575 the DC feeding GND Is at metal_3_bot while the RF signal has ground at metal_2_mid. The DC connector is HUGE as shown below.
basicly i need to simultaniosly feed all 4 amplifiers as shown in schematics below.
From looking at the data sheet i have this schematics shown in the last photo.
How do i build a feeding network for such a complex connector so if will feed all 4 amplifiers shown in the schematics below.
Thanks.
https://www.qorvo.com/products/p/QPA2575
basicly i need to simultaniosly feed all 4 amplifiers as shown in schematics below.
From looking at the data sheet i have this schematics shown in the last photo.
How do i build a feeding network for such a complex connector so if will feed all 4 amplifiers shown in the schematics below.
Thanks.
https://www.qorvo.com/products/p/QPA2575
