Hellow guys.
i am designing a power inverter using egs002 board, before going to make all connections i wanted to run my egs002 board at stable mode i-e LED should not blink, it should glow continuously, i connected a proper voltage feedback, temperature feedback connected to ground, IFB connected to ground, and fan control left open, powered 5V and 12V, but the LED blinks two times and off for 2 seconds and keep repeating, that means over current.
Now i need help , what should i do ??
i want to disable current sensing for now or get rid of this problem ? i just want to run board smooth.

 

Need circuit diagram to help you further..

 

Need circuit diagram to help you further..

sir thankyou so much for your reply,
According to data sheet of Egs002 board, I have grounded IFB, VS1, VS2 and TFB, connected 3 volts to VFB as feedback for test, LED should glow normal, but it indicates over current error, blinks twice and off for 2 seconds.