I am building a second seat for my snowmobile and in doing so i am adding 12v 10 watt hand warmers and a seat warmer. I belong to a snowmobile forum and after discussing it with the higher ups we figured it would be easier to just run 12v AC power straight from the power source off of the stator. this worked perfectly except that now the hand warmers are getting too hot. what do i do. i have practically no knowledge of electronics/circuits. ill attach my best attempt at drawing this wiring for anybody who wants to help. the hand/ seat warmers are supposed to get 12v 10 watts of power. i'm fine going over that but is there a way to maybe vary the power they get to adjust the heat? part of the problem s that the stator at idle will produce 12-14 volts but once the rpm increases it can go from 12v to close to 30v. Thanks for any help
Attachments
-
41.8 KB Views: 6