Compaq 8510w - shorted cable. Working on battery only

Thread Starter

LauraB

Joined Dec 15, 2011
43
Hi,
Accidentally, while fixing the cable I connected plus with minus. I attach the datasheet, if someone may take a look...
I measured some things before I started repairing:
Q8:
S: 19.4V
G: 19.0V
D: 0.01V

Q7:
S: 0V
G: 0V
D: 0V

Q642 and Q643 DSG = 0V
pin 26 U614 (bq24703) = 0V

comparator U606
1- output1 = 9,5V
2-in1- =6V
3- in1+ =6V
4 - GND
5-in2+ =5V
6-in2- =6,4V
7-out2 =18,7V
8-VCC =19,4V

I repleaced the comparator U606

Laptop is working but only on the battery. And the battery is recharging only when the notebook is turned OFF. When it's ON it works on the battery without recharging.
I measured U606 again:
1- output1 = 3,3V
2-in1- =5,9V
3- in1+ =7,3V
4 - GND
5-in2+ =5V
6-in2- =7,3V
7-out2 =0V
8-VCC =19,4V
Did I miss anything?
 

Attachments

R!f@@

Joined Apr 2, 2009
9,918
How's the charger now.
Can you measure the charger output while the lap is switched on and charger plugged in to the lap.
Measure at the jack end not at the charger PCB
 

R!f@@

Joined Apr 2, 2009
9,918
If you are getting 12V at the socket tracks on the PCB ( laptop PCB where the socket is soldered ) then it is obvious you have a faulty socket or a jack

When plugged in with charger connected and lap on you should get the rated adapter voltage at the PCB terminal, no more no less.
 

Thread Starter

LauraB

Joined Dec 15, 2011
43
Im getting 12V when measuring 1 and 2 pin on Jack socket page 5 datasheet. Should I get there 19V? How is possible to destroy a socket by switching the +- cables?
 

R!f@@

Joined Apr 2, 2009
9,918
apparently you did destroy the jack or it was broken before.

{ed}
not between 1 and 2

pin 2 is ID pin.

Check between pin 1 OR 3 and ground ( pin 4 to 9 )
 

R!f@@

Joined Apr 2, 2009
9,918
It seems the lap uses an ID pin, if so another charger might not even work.

You would need the OEM charger.
 

Thread Starter

LauraB

Joined Dec 15, 2011
43
It looks like original charger. Its difficult to localize the right pin without a pcb view schematic. But im trying.
 
Top