I am trying to create a control system to sense temperature on Circuit Wizard however I am struggling. I need:

1. Circuit design diagram
2. Flowchart programme
3. PCB layout

Any help or guidance will be greatly appreciated.

 

With an open-ended query like that the question is: Where to start?
You will no doubt get many 'I did it like this' answers, many of which will have some elements of use to you and some will be over-complex or downright useless. How will you know the difference?

So my response to you is: What are you looking for? A solution or an education?
With more understanding of your requirement I could give you a complete solution, but that wouldn't help you understand why it works and how to design from scratch.

Define the problem clearly. How much electronics & software development experience do you have? What do you already know about solving your requirement?

 

I am trying to create a control system to sense temperature on Circuit Wizard.

What sort of 'control system to sense temperature'? This is a bit ambiguous. Do you want something like a thermistor attached to a circuit that at a certain temperature the circuit activates another device?

 

Maybe start with the LM35 precision temperature sensor's PDF and the typical examples.
LM35 Precision Centigrade Temperature Sensors datasheet (Rev. H)

And Welcome to AAC!

I typically use them with an Arduino UNO to do Cent. to Far. conversions and scaling adjustment for accuracy.

 

There is not enough information.
Just an idea but....If it's basically a thermostat circuit then a battery/power supply, an LM358, a thermistor, an LED and a few resistors would be enough.
This would then switch on the LED when the thermistor is at about 30°C and switch off when the thermistor is at about 20°C