All About Circuits

Capturing ATMEGA328P's RESET pulse on a scope

E

Thread Starter

electrophile

Joined Aug 30, 2013
167
I recently bought a Rigol DS1054Z scope and I wanted to capture the RESET pulse on a ATMEGA328P's reset pin when its being programmed. From what I've read in the manual it looks like I need to set the trigger to falling edge (since the DTR pulse is active low), set it for single shot trigger and maybe set the trigger to a few mV higher than 0V? Could anyone help me with this?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
MikeA Capturing 0-2v AC with 3.3V ADC Analog & Mixed-Signal Design 21
SamR Capturing a Frequency Sweep on a Digital Scope Test & Measurement 18
M compile reports after capturing votes Off-Topic 1
Sparky49 Capturing HP1650B Screens using GPIB General Electronics Chat 2
Rolland B. Heiss Capturing energy that is flowing out and normally lost. General Electronics Chat 62
Similar threads
Capturing 0-2v AC with 3.3V ADC
Capturing a Frequency Sweep on a Digital Scope
compile reports after capturing votes
Capturing HP1650B Screens using GPIB
Capturing energy that is flowing out and normally lost.

You May Also Like

Top