Craftsman 19.2 v Impact wrench, won't turn on.
Model No. is 315.116020
When I opened it up, I found a burnt wire on one capacitor mounted in the trigger.
I fixed that, but still nothing.
Later, I found a piece half of another capacitor laying in the hollow of the grip.
It was a hard plastic cap with the numbers 8A4 MIC
It doesn't look like any that I have.
The wire ends are very thick, like a high voltage cap from a Microwave Oven.
Can I bypass these two capacitors?
I've never seen a trigger with caps before.
If not, where can I buy one? (I don't see it on Ebay)
Thanks,
Gary
Model No. is 315.116020
When I opened it up, I found a burnt wire on one capacitor mounted in the trigger.
I fixed that, but still nothing.
Later, I found a piece half of another capacitor laying in the hollow of the grip.
It was a hard plastic cap with the numbers 8A4 MIC
It doesn't look like any that I have.
The wire ends are very thick, like a high voltage cap from a Microwave Oven.
Can I bypass these two capacitors?
I've never seen a trigger with caps before.
If not, where can I buy one? (I don't see it on Ebay)
Thanks,
Gary
Attachments
-
139.5 KB Views: 72