Hi guys. I want to callibrate the volt per division on my CH X (CH 1) on my old oscilloscope but I am not able to find a service manual that shows the trimmer pot locations. Does anyone possibly know where I can locate a service manual for my device (Im not too sure one actually exists)
My oscilloscope in question is a Pintek PS-605 (it has simply been rebranded to Dick Smith in the photo)
Thanks in advance guys. Any help would be appreciated!
![IMG20240201211547.jpg IMG20240201211547.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301722-f7e629e6def4805b0e1a6606af67bb68.jpg)
![IMG20240201211711.jpg IMG20240201211711.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301723-d494c0de8b93397a853b9fcda5908140.jpg)
![IMG20240201211739.jpg IMG20240201211739.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301724-c4c53fafb15ccaa78996bd373982e8aa.jpg)
![IMG20240201213045.jpg IMG20240201213045.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301725-a88233ca5e97d7aff0e31d13e7473ff3.jpg)
My oscilloscope in question is a Pintek PS-605 (it has simply been rebranded to Dick Smith in the photo)
Thanks in advance guys. Any help would be appreciated!
![IMG20240201211547.jpg IMG20240201211547.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301722-f7e629e6def4805b0e1a6606af67bb68.jpg)
![IMG20240201211711.jpg IMG20240201211711.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301723-d494c0de8b93397a853b9fcda5908140.jpg)
![IMG20240201211739.jpg IMG20240201211739.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301724-c4c53fafb15ccaa78996bd373982e8aa.jpg)
![IMG20240201213045.jpg IMG20240201213045.jpg](https://forum.allaboutcircuits.com/data/attachments/301/301725-a88233ca5e97d7aff0e31d13e7473ff3.jpg)