What are the 'scope settings ?

Timescope

 

I took that last night.. it was 2v/div @ .2us I think.Everything is off now but ill be back in there tomor and turn those settings back on and post some more with it Its great ,I have high hopes with it.

 

That will be good.

Timescope

 

This one with scope settings are 2v/div @ 1ms.

 

I have brightened it up a bit . That would be 2 pulses per microsecond. Is the scope in the "cal" position ?

Timescope

 

its showing its at 2khz on the 1/sec setting.I don't see a cal on it any hwere other than the var on the volts/div knobs.

 

I apologize Timescope, it says 2v/div @ 1m/s .I had u.s. on my mind for some reason.

 

This scope has a calibrator at 1khz.At 1 m/s a 1khz pulse fits between each box.

 

Well done. So we have a pulse repetition rate of 2 kHz. You can adjust the spacing between the pulses with R12.

Timescope

 

im actually using a 555 circuit i had allready put together, it has an adjustable frequency and duty cycle and seems to be working fine.

 

im actually using a 555 circuit i had allready put together, it has an adjustable frequency and duty cycle and seems to be working fine.

So the waveforms are not produced by the TSG circuit that I designed ?

 

yes they are.. im just using a diffrent 555.Your TSG circuit has a 555 input and i allready had 555 circuit together to use.

 

i didnt have the 1.8 nf cap ...i had to use a 2.2 nf cap in its place.i can post thee 555 schematic if you need it ?

 

Ok, I understand, you used a 555 astable that you had already built and added the LT1632 circuits.

I will upload the other circuits tonight when the internet line is faster.

Timescope