Completed Project 3D Printed Wire Storage for Protoboards

Thread Starter

Wendy

Joined Mar 24, 2008
23,053
Jumper storage.jpg
Something I came up with to store pre-bent 3 servers wires bought from Amazon. Hesitated to post this but I thought it might be something people would like to see. I have attached the 3D files for those who would like to print one like it. It uses Qty 2 5/16" x 1/8" and Qty 2 1/16" x 1/8" Neodymium magnets. I used black duct tape to make a hinge. The holes are oversized, they were the smallest my printer could reliably make. I did make one with smaller holes but it was too hard to get the wire into them.
 

Attachments

Last edited:
Top