All About Circuits

24V 400W 19A

F

Thread Starter

fakesoul

Joined Feb 24, 2020
1
Hello to all,

I'm Alex, nice to meet all of you :D
I'm new at this forum, I came wherefrom research and I thought maybe I can ask someone where.

So I have a LED LAMP, feed by a 24V (car/firefighter) and times to times the battery needs to be charged, so we turn on the engine and the alternator, start the job, but the problem yes when this is start, the value of the V=+/- 28V output.

What can I do to get only the 24V on the LED LAMP?

Could anyone give me a help?

Don't matter if its DIY


Best to all
Alex :D
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
J Can't set amperage on 400w 15A DC-DC step up boost converter 10-60 volts Power Electronics 39
C Is a 500w switching power supply enough for a 400w motor at high draw+additional power supply questions. General Electronics Chat 10
Rahulk70 Completed Project Can I run a Mercury Vapor Lamp of lower wattage (400W) on a 1000W MHL ballast? Power Electronics 29
BlackMelon Driving a 48V 400W DC motor from a single phase 220V 50Hz AC: Comparison between two topologies. General Electronics Chat 1
Paulo Lavarias 400w TDA2030A OR 200WTDA2030 PCB Design? PCB Layout , EDA & Simulations 1
Similar threads
Can't set amperage on 400w 15A DC-DC step up boost converter 10-60 volts
Is a 500w switching power supply enough for a 400w motor at high draw+additional power supply questions.
Completed Project Can I run a Mercury Vapor Lamp of lower wattage (400W) on a 1000W MHL ballast?
Driving a 48V 400W DC motor from a single phase 220V 50Hz AC: Comparison between two topologies.
400w TDA2030A OR 200WTDA2030 PCB Design?

You May Also Like

Top