Hi,
This Motor token from a old Maytag Washer machine in good working conditional.
How can wiring up and run it out side of the machine?
Thanks
Adam

 

Being a switched reluctance motor, you need to know how it was hooked up to the controller?

 

Being a switched reluctance motor, you need to know how it was hooked up the controller?

Thanks.
Pictures attached are the diagram from manual book.

 

Looks like you need to connect the motor and tach up to the controller board and trace where power and control come from and draw it out.
There can't be much more off board than shown.

 

Looks like you need to connect the motor and tach up to the controller board and trace where power and control come from and draw it out.
There can't be much more off board than shown.

Thanks.
The control board as pictures attached, kind of complex.
Is that a 3 phase motor, can I just use the diagram below to run it?