heater

Hi, I've a 6kw water heater that according to the specs should work on single phase, however I'm not sure how to wire it. I've read here on the forum similar issues, however the heating element had a different arrangement. As you can see, mine has like a star shaped common (I tried to connect...

Hi My car has a Propex HS2211 After pressing ignite button, It waits for air pressure check then it ignite and the flame start burning but it shutt off after couple of secs (5 sec). After few trues it gives me error code with 4 blinks I tried different gas pressure from 10-13 WC and also as...

Can anyone tell me what these are so I can find and buy the adapters to get the appliances going? I reckon they’re old, do you think I can still find them somewhere? They are attached to waterbed heating matts. Cheers all

Hi everyone, I am replacing a caravan propane heater which was a duct heater. I have gotten rid of gas and so now need to replace with something like this and a fan: https://www.ebay.co.uk/itm/113870595604 Only problem is that the heater does not have a connection for the thermostat like it...

I have a 3 tier reptile tank, but apparently there are not other things to heat them other than lamps an mats. Needless to say I need to know if there is a way to build a circuit (or buy) one that can also regulate the temperature output with an accuracy of 1+/- degree. I basically am going to...

Hello i have to heat a petri dish for some appliances , and i would love to know which recomandations of heater can you please give me ? It is for small samples . thanks

Hello folks, I have an old Omega CN-9121 PID Controller and a 105Watts 115V Fibre heater mantle with an inbuilt K-type CHromel-Alumel temperature thermocouple also attached into it. I plan to use the PID controller to control the temperature of the heater. Looking at the manual below: Manual...

Hi. I'm trying to assemble the components to drive a single-Nichrome-wire device for heating sheets of thermoplastic. To get the material up to 350˚F should take about 3-4 amps with 20 gauge wire, so the power supply needs to deliver at least 5 amps. I know how an AC-to-DC power supply...